Tuesday, January 31, 2017

It Works! and Voltage Regulation

     Using the diagram of the teensy's pin layout I was able to correctly connect the accelerometer and now it works. To test and perfect its accuracy I want to be able to put it on my wrist and walk with it. This was hard to do because the teensy was getting power from my laptop so I needed a way to power the teensy with a 9V battery. The teensy takes 5V so plugging in a 9V battery would fry it. So I used this guide to make a regulator. Its input is 9V and its output is 5V.  After making sure the regulator was outputting 5V with a voltmeter, I plugged into the teensy and everything seems to be working.
     I also found a smaller display. It should connect the same way as the current display but I am sure it will not be as easy as switching them out.


     For next week I will test the pedometer. I'll try to condense it as much as possible by using a smaller breadboard and shorter wires then secure it to my wrist.

Voltage Regulator 
9V battery powering the pedometer

No comments:

Post a Comment